Emergency Plumber in Lake Stevens, WA

A drain snake (auger) is a rotating cable that physically breaks through or pulls out a blockage. It's effective for clearing a clog that's relatively close to the drain opening. It does not clean the pipe walls - it creates a hole through the obstruction and leaves grease, scale, and debris coating the interior. Hydro jetting uses pressurized water (up to 4,000 PSI) that scours the pipe walls completely clean, removing everything including biofilm and mineral deposits. Snaking is appropriate for a simple, first-time clog. Hydro jetting is the right choice for recurring blockages, significant grease buildup confirmed by camera, root intrusion that keeps returning, or pre-inspection preparation of a sewer line before lining.

The answer depends on the unit's age and what failed. Below 8 years old: repair almost always makes sense unless the tank itself is leaking (tank leaks cannot be repaired - only the tank body holding the water). Between 8–12 years: evaluate the repair cost versus replacement. A failed heating element ($150–$250) is worth repairing. A failed thermostat ($100–$200) is worth repairing. A leaking tank or a repair that costs more than 50% of a new unit is the tipping point for replacement. Over 12 years with any internal failure: replacement is typically the right financial decision because the remaining life expectancy doesn't justify the repair cost. We give you the honest math, not the most profitable recommendation.

A slab leak is a leak in a supply or drain pipe that runs beneath your concrete foundation. Because the pipe is under the slab, water from the leak doesn't surface immediately - it migrates through the concrete and soil, often showing up first as warm spots on the floor, unexplained water bill increases, or the sound of water running when everything in the house is off. Left unaddressed, slab leaks cause significant structural damage: the water erodes the soil under the slab, which can lead to foundation settling, concrete cracking, and mold growth in the subfloor. Detection is done non-invasively using acoustic listening equipment and thermal imaging cameras. Once pinpointed, the repair is typically done through a targeted access cut rather than breaking up large sections of floor.

Sewer gas entering your home without a visible overflow typically comes from one of three sources: a dry P-trap in a rarely used drain (the water seal evaporates and lets gas through - fix by running the faucet for 30 seconds), a cracked or improperly sealed wax ring at a toilet base, or a venting problem in the drain system causing negative pressure. In older homes, cracked sewer line joints can also let gas escape underground before the pipe fully fails. The smell is not just unpleasant - hydrogen sulfide is harmful at elevated concentrations. We can identify the source quickly and give you a clear answer before it becomes a health or structural issue.